What's The Job Market For Peugeot 308 Key Fob Professionals?
asked 2 weeks ago
Peugeot 308 Key Fob Replacement
Peugeot’s 308 might be somewhat old-fashioned however it’s still striking. It’s not the most luxurious vehicle in its class, but it is an enjoyable and relaxing driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. These tips can aid in solving the issue whether it is intermittent, or constant.
Water Damage
If you accidentally drop your key fob into the puddle, or it gets wet while kayaking canoeing, rafting or canyoning, the fob is likely to be damaged by water. The best way to avoid this from happening is to keep it in a dry, dry bag when you’re outdoors or performing activities that require the fob to be exposed to a lot of water.
You’ll also want to ensure that the fob is completely dry prior to opening it and reusing it. If you notice any smells emanating from the fob (such as industrial fluid or windshield washer fluid) This is a further indication that it’s submerged.
A wet circuit can cause the battery’s charge to be drained or even explode. If you can remove your 308 keyfob out of the water and turn it upside up and shake as much water out as possible before opening the casing. After opening it, take out the battery, and then clean the circuit board using a cotton swab dipped in 90-percent isopropyl alcohol.
Other reasons why your Peugeot 308 remote entry keyless system may not work include a dead coin cell battery or receiver module malfunction signal interference, or a damaged chip. If none of the above is the problem you can reset the system by removing the 12 volt battery from the car for 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote start system that allows the driver to start the car from a distance while warming up or cooling down the vehicle prior to stepping inside. This feature is extremely useful especially during the cold winter months. However, there are times when the remote stop system stops operating due to a range of reasons, like a dead coin battery.
The coin-shaped battery located inside the key fob can last between two and four years based on how often it’s used, peugeot 308 Key Fob the location it was purchased, and how it is utilized. The date of use is typically printed on the package or written in the manual.
If the key fob has stopped working after exposure to water that is clean it is recommended to remove the battery, then clean the chip using a paper towel and isopropyl ethanol, then dry it thoroughly before replacing it. In case of exposure to salty or soapy water, the chip might be damaged and you’ll need to replace the key fob altogether.
If you’re not sure if the battery is defective it is possible to check its voltage with a multimeter that is connected to both the terminals plus and minus. The voltage should range from 12-13 volts however, if it reads lower, the battery must be replaced. You can also reset your onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should now begin.
Faulty Receiver Module
If you’re not seeing the “Key Detected” message on your dashboard, then it’s possible that the receiver module has been afflicted with a fault. It’s the component that transmits a signal when your key fob is activated. It also acts as an alarm and prevents the car from starting if you don’t have the correct key.
This could be due to a number of causes, such as water damage or simply ageing. If your Peugeot 308 key fob has been exposed dirty tap water, for instance the electronic chip inside is damaged. In this case, you’ll need to take off the battery and clean it thoroughly using isopropyl alcohol, or electronic cleaner. Once it’s dry, you can put the battery back in and try it again.
If the issue persists, it’s probably a good idea to seek out an area Peugeot specialist or locksmith. They can employ the diagnostic tool to pinpoint the issue and Peugeot 308 key fob repair it.
It is stressful to lose your Peugeot car key. A qualified auto locksmith can solve the problem within minutes. They can cut a brand new key and then program it into your vehicle, making sure you’re to the road as quickly as possible. Click here to locate a locksmith near you.
Faulty Electronic Chip
The chip inside your peugeot boxer key 308 key fob is an important part of the remote control system. If the chip is damaged, you may experience difficulties starting your vehicle or receive a message saying “anti-theft”. If this occurs, the only way to fix the issue is to purchase a new key. Fortunately, professional auto locksmiths are able to provide this service in the shortest amount of time.
The chip in your Peugeot 308 key fob can fail due to sweat, water damage, dirt or other reasons. If your Peugeot 308 key fob is exposed to soapy water, it is recommended to clean it immediately. You can use a paper towel and isopropyl alcohol to clean the electronic component. After that, allow the battery to dry completely.
Sometimes keys can cease to function due to radio interference. This could be caused by other devices operating at the same frequency as your Peugeot key fob. This can be caused by poor conditions or objects within the vicinity of the vehicle. If you encounter this issue you should visit a Peugeot dealership.
The Peugeot Key Fob 207/308 is delicate and needs special attention. You shouldn’t drop it or throw it around. If you lose it, try to find it as soon as you can. You can reset your on-board computer by disconnecting the battery for a couple of minutes. Make sure you disconnect the negative cable first, then the positive.